الوصف الوظيفي
1) Sets up and operates machine to bend metal structural shapes, such as bars, rods, angles, pipes, and tubes, to angle or contour specified by work order, drawings, templates, or layout: Selects and bolts holding clamp, die block, and guide clamp to a machine.
2) Positions and clamps end stops on the machine to set the specified location of the bend.
3) Inserts or screws plug stops into guide wheel to set specified degree of bend.
4) Positions workpiece against the end stop.
5) Locks holding clamp and guide clamp onto the workpiece.
6) Lubricates the workpiece with oil.
7) Starts turntable that draws workpiece through guide clamp around die block until stopped by plug stops or until dial indicator points to a specified degree of bend.
8) May slide mandrel into tubing instead of using guide clamp
9) May preheat workpiece, using hand torch or heating furnace.
10) May use a hand-powered bending machine for short runs.
11) May fill tubes or pipes with sand, resin, or lead to prevent wrinkling or collapse during bending operation.
12) May heat tube, using a torch, and manually bend tube or pipe around forming blocks.
13) May flare tube ends, using tube flare and cut or trim metal stock to length, using power shears or saws.
14) May be designated according to the type of stock bent as Pipe-Bending-Machine Operator; Rod-Bending-Machine Operator I; Tube-Bending-Machine Operator.
المهارات
Minimum of 5 years experience in Panel board manufacture
تفاصيل الوظيفة
منطقة الوظيفة جدة, المملكة العربية السعودية
قطاع الشركة الصناعات الثقيلة
طبيعة عمل الشركة صاحب عمل (القطاع الخاص)
الدور الوظيفي الإدارة
نوع التوظيف دوام كامل
الراتب الشهري غير محدد
عدد الوظائف الشاغرة 1
https://www.bayt.com/ar/saudi-arabia/jobs/bending-operator-4524380/
Printable Page 
Report Advertisement